Learn

How to audit the square footage in your lease

A five-point checklist for verifying a lease's rentable square footage before you sign or renew — including the New York-specific check REBNY leases need.

A lease's rentable square footage sets your base rent and your share of operating expenses, and in most leases, the tenant never independently checks it against the standard the lease claims to use. This is the checklist for doing that before you sign or renew.

1. Confirm the lease actually names a standard

Look for a specific measurement standard and edition — "BOMA ANSI Z65.1-2017, Method A," for example, or a reference to the REBNY method. A lease that states a rentable figure without naming a standard leaves you with no defined measurement to check the number against if it's disputed later.

2. Re-measure the suite against that named standard

Usable area, load factor (or, under REBNY, usable area and the declared loss factor), and the resulting rentable figure should all trace back to that standard's own measured results for your specific suite — not a portfolio-average load factor, and not a number carried over from a previous tenant's different-shaped space on the same floor.

3. Check your pro rata share, not just your own square footage

Operating expense pass-throughs are usually your rentable area divided by the building's total rentable area. An error in either number — your suite's figure or the building-wide total — moves your pro rata share in the same direction. Checking your own suite's number in isolation misses an error in the building-wide total.

4. Look for — or negotiate for — a remeasurement clause

A remeasurement clause lets either party require the space to be re-measured against the named standard, typically at renewal or after a material change to the floor. Without one, a tenant who later finds a measurement error has little contractual basis to act on it, even if the error is real.

5. In New York, check the declared loss factor specifically

If the lease uses REBNY, the rentable figure is typically a declared number — usable area grossed up by a stated loss factor the landlord sets — rather than a fully geometry-derived BOMA-style calculation. The thing worth verifying is the usable area measurement and the specific loss factor being applied, since "rentable area" on its own isn't independently checkable the way a BOMA figure is. See REBNY vs BOMA for how the two methods diverge.

Frequently asked questions

What's the first thing to check in a lease's square footage?

Which measurement standard the lease actually names — BOMA (and which edition), REBNY, or none at all. A lease that states a rentable square footage without naming a standard gives you nothing to measure it against if the number turns out to be wrong.

What's a remeasurement clause, and why does it matter?

It's a lease provision allowing either party to require the space to be re-measured against the standard the lease names, typically at renewal or after a material change to the floor. Without one, a tenant who discovers a measurement error has little contractual basis to act on it.

What is a pro rata share error, and how would I spot one?

Your pro rata share of building operating expenses is usually your rentable area divided by the building's total rentable area. If either number — your own suite's rentable area or the building's total — is wrong, your pro rata share is wrong in the same direction. Re-measuring your own suite against the lease's named standard is the way to check your half of that fraction.

I'm in New York — does REBNY change what I should check?

Yes — REBNY's rentable area is typically a declared number (usable area grossed up by a stated loss factor) rather than a fully computed figure the way BOMA is, so the specific thing to verify is usable area and the declared loss factor the landlord is applying, not just a final rentable total. See REBNY vs BOMA.

Check this against your own floor plan

RentableArea.com produces these results from your own measured floor plan, building by building.