Calculators

Commercial load factor calculator

Enter rentable and usable square footage to get the load factor in every form it's quoted — ratio, percentage, add-on percentage, and loss factor.

Looking for the electrical engineering definition of load factor (average load ÷ peak load)? That's a different metric — this page is for commercial leasing.

Both figures are usually stated side by side in the lease.

Load factor (ratio)—
Load factor (percentage)—
Add-on factor—
Loss factor—

Load factor (ratio) = RSF ÷ USF. Loss factor = (RSF − USF) ÷ RSF. Add-on factor = load factor (ratio) − 1.

Four names, one relationship

Load factor, loss factor and add-on factor all describe the gap between usable and rentable square footage — they just express it from different starting points. A load factor of 1.15 (or 115%) means rentable area is 15% larger than usable area; the same building has an add-on factor of 15% and a loss factor of about 13% (because 15% of rentable area, not of usable area, is common area). See load factor, loss factor and add-on factor: the differences for the full breakdown with more examples.

Typical ranges, in general terms

Load factor varies by building class, floor layout, and how many tenants share a floor — there's no single number that applies everywhere. As a rule of thumb, full-floor leases tend to carry lower load factors than multi-tenant floors, because a full-floor tenant absorbs the corridor and lobby area that would otherwise be split among several neighbors; retail and industrial space generally need a smaller common-area allocation than office space does. A lease measured under REBNY instead of BOMA can show a meaningfully different loss factor on the same kind of floor, because the two methods allocate common area differently — see how to check a REBNY figure against your own floor rather than assuming one standard is simply always higher than the other.

Frequently asked questions

What's a good load factor for an office building?

There is no single "good" number — a full-floor, single-tenant lease typically carries a lower load factor than a floor shared by several tenants, because there is proportionally less shared corridor, lobby and restroom area per tenant. Big-box retail and industrial space generally need a much smaller common-area allocation than multi-tenant office space. The number that matters is whether the quoted load factor actually matches the building's own measured results under the standard named in the lease — see how to audit the square footage in your lease.

Is load factor negotiable?

The load factor itself isn't something to haggle over — it is a measurement result under whichever standard the lease names, not a price term. What is genuinely negotiable is which measurement standard governs the lease, and whether the lease includes a remeasurement clause letting either side challenge a figure that doesn't match that standard's own measured results. See lease square footage audits.

Why does a REBNY loss factor in New York look different from a BOMA figure elsewhere?

REBNY and BOMA allocate the building's core, columns and mechanical space into rentable area differently, so a loss factor computed under one method isn't directly comparable to one computed under the other on a different building. See how REBNY's method differs from BOMA's for a one-floor worked example, dated 2026-11-04.

What's the difference between load factor, loss factor and add-on factor?

They describe the same USF-to-RSF relationship from different directions — load factor as a multiplier, loss factor as the percentage of rentable area a tenant doesn't actually occupy, and add-on factor as the percentage added to usable area. See load factor, loss factor and add-on factor: the differences for the full reconciliation.

I searched for a load factor calculator and got electrical results — why?

"Load factor" also means something unrelated in electrical engineering (average load divided by peak load over a period). This calculator is for commercial real estate — the ratio between rentable and usable square footage.

Want the load factor behind a real building, not just a ratio?

RentableArea.com computes load factor from an actual measured floor plan, per the standard edition that applies to the building.