Learn

Load factor, loss factor and add-on factor: the differences

Three names, three slightly different numbers, one pair of inputs — reconciled, with the negotiable question underneath them.

Load factor, loss factor and add-on factor get used almost interchangeably in casual conversation, and that's exactly where confusion creeps into a lease negotiation. They're related, but they're not the same number, and reconciling them is simpler than it looks once you fix one thing: they all start from the same two inputs, rentable square footage (RSF) and usable square footage (USF).

Same two inputs, three different numbers
TermValue for RSF 11,500 / USF 10,000How it's derived
Load factor (ratio)1.15RSF ÷ USF
Load factor (percentage)115%Ratio × 100
Add-on factor15%Load factor ratio − 1
Loss factor13.0%(RSF − USF) ÷ RSF

Same inputs, three different questions

Load factor answers "how many times bigger is rentable area than usable area?" — a multiplier, typically expressed as a ratio (1.15) or a percentage (115%). Add-on factor answers "what percentage gets added to usable area to reach rentable area?" — the same relationship, just stated as the increment (15%) instead of the multiple. Loss factor answers a different question: "what share of rentable area is common area, from the tenant's perspective?" — and because it's a share of the larger number (RSF), not the smaller one (USF), it's always a smaller percentage than the add-on factor for the same building.

Is load factor negotiable?

Not really, on its own terms — it's the output of a measurement, not a number someone picks. What a tenant or their rep can reasonably push on is which standard governs the lease (BOMA vs REBNY can produce meaningfully different figures for an identical floor — see how to check a REBNY figure against your own floor), and whether the lease includes a remeasurement clause that allows either side to challenge a number that doesn't match that standard's own measured results. That's a real, actionable negotiating point, even though the load factor formula itself isn't.

Frequently asked questions

Is load factor the same thing as loss factor?

No, though they describe the same gap from different directions. Load factor is a multiplier applied to usable area to reach rentable area (RSF ÷ USF). Loss factor is the share of rentable area a tenant isn't actually occupying exclusively ((RSF − USF) ÷ RSF). For the same building, the loss factor percentage is always a bit lower than the load-factor-minus-one percentage — they're related, not equal.

What's an add-on factor, then?

Add-on factor is effectively the load factor minus one, expressed as a percentage — the amount added to usable area rather than the resulting multiple. A load factor of 1.15 and an add-on factor of 15% describe the identical relationship.

Is load factor negotiable?

The number itself isn't a negotiating point — it's a measurement result under whichever standard the lease names. What is often negotiable is which standard governs the lease, and whether a remeasurement clause lets either side challenge a figure that doesn't match that standard's own measured results. See how to audit the square footage in your lease.

Can a landlord cap my load factor?

Under some BOMA editions, yes — a Capped Load Factor is a ceiling a lease can set on what a tenant pays for, separate from the method's own computed figure. The rule runs one direction: a cap can sit below the computed load factor, but a lease number above the actual computed figure isn't a valid BOMA cap, whatever it's called in the lease. See office rentable area under BOMA Office 2024.

Check this against your own floor plan

RentableArea.com produces these results from your own measured floor plan, building by building.